To programme or read CV select from menu: 'Engines' => 'Decoders programming'
Introduction
Not all DCC System can programming or/and reading DCC:
Roco system: can programming decoders but can't read CV. Can't programming in PoM (Programming on Main) mode.
Lenz system SET-100 or SET-90: can both read and write CV. Can programming in PoM mode.
Before first read or write CV you must connect with DCC Systems.
Tab 'Parameters'
On this tab you should:
DCC System: select DCC System which will be used to programming.
Programming mode: select programming mode:
- Direct mode - most often used method
- Paged mode - older method used if previous failed
- PoM - newest method used without stopping trains (but can't read CV)
Engine - you can select one of defined engine or 'Other engine'. If you select one of defined engine than all reading and writing values will be remembered with engine. If you select 'Other engine' and PoM method then you must type in decoder address.
CV descriptions: - select CV descriptions for decoder in this engine. Or you can select '<standard>'. See: Engine CV database
Reading CV
To read CV you should (on tab 'Read/Write CV'):
select on left list CV or type in CV number on 'CV number' field
press button 'Read CV'
To read whole group of CV:
select group or any CV from this group on left list
press button 'Read group'
To read all known CV
press button 'All' (next to 'Read group')
Read value is showed on following fields:
Value: value in decimal format
hex: value in hexadecimal format
bits: value divided to bits
meaning: for more CV you can read description of this CV
if value is remember with engine then is showed on left before CV name
If you want to compare remembered values with current values from decoder you should select 'Compare' before reading. In such situation:
read value is showed in fields 'Value'
previous value is showed on fields 'Previously'
Writing CV
To write value to CV you should:
select CV on left list or type in CV number in field 'CV Number'
type in value in field 'Value' or 'hex' or set bits
press button 'Write CV'
If there are remember CV values on CV group you can write to decoder:
Write group - save all values from current group to decoder
All (next to 'Write group') - save values from all known CV on list
End of programming
On first reading or writing DCC System is switched into 'Programming mode'. To switch off 'Programming mode' just press button 'End of programming' or close window.